Installation & Assembly

WAC Lighting
www.waclighting.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. JULY, 2014
FEED OPTIONS
• Make sure power is o before wiring.
• Note the polarity indicator of the track and accessories.
Live End Connector (WEDL / WEDR)
1. Slide live end connector into track and secured screw (Fig 4a).
2. Remove the cover.
3. Bring feed through either the knock-out on the bottom
of the connector or on the side of the connector (Fig 4b).
4. If bringing feed through the knock-out on the bottom of
the connector be sure that the knock-out cover is installed
on the side of the connector.
5. Wiring (Fig 4c).
6. Replace the cover.
INSTALLATION INSTRUCTION
W Track Surface Mount 277V
WHT4, WHT8, WHT12