Installation & Assembly

09/12/06 Rev 1
INSTRUCTIONS: Model: QP-501 Pendant Socket Set
INSTRUCTIONS PERTAINING TO A RISK OF FIRE,
OR INJURY
Lighted lamp is HOT!
WARNING- To reduce the risk of FIRE OR INJURY:
Turn off all power and allow to cool before replacing
lamp.
Lamp gets HOT quickly! Contact only switch/plug
when turning on.
Do not touch lens, guard, or enclosure.
Keep away from materials that may burn.
Do not touch the lamp at any time. Use a soft cloth.
Oil from skin may damage lamp.
Do not operate the luminaire with a missing lens or
damaged shield.
Save these instructions.
Overview: Pendant sockets sets are designed for
use with all WAC quick connect adapters. They may
also be used on other manufacturers brand of quick
connect (consult factory for compatibility). Pendants
may be mounted to mono rail, monopoints, or line
volt track, by coupling to a low voltage quick connect
adapter. Sockets are supplied with a 6′cable and may
be field cut to desired length.
Installing Lamp & Shade:
1. Insert the lamp into the fixture by aligning the
pins with the socket holes, and gently
pushing until lamp seats.
2. Use 12V 50W bi-pin Halogen lamp with
G6.35 base (supplied) with 12V 50-watt
Halogen (24V lamp may be used depending
on power supply ).
3. Position shade so that threads go through
the hole in the shade and screw on Bulb
Shield from below.
(See diagram).
Installing Pendant to Quick Connect:
1. Insert the post of the quick connect into the
quick connect adapter.
2. Thread the top half of the conical section until
it seats with the adapter.
3. Adjust fixture position, use caution not to
loosen the conical section.
Accessories: series G500 glass shades.
See reverse for field shortening pendants.
Installing Lamp & Shade
QP-501 Socket
Shade
Lamp
Bulb Shield
Installing to Quick Connect
Quick connect adapter
Top Conical section