Track Head Installation Sheet

INSTRUCTIONS Low Voltage Track Fixture
Model: JHT-874-LENS JHT-874L-LENS
Caution:
Read all instructions before installing.
Switch off power before installing or re-lamping.
Do not attempt to energize anything other than a track light fixture.
All installation shall be in accordance with NEC and all local codes.
To reduce the risk of a burn during re-lamping, remove from the track before re-lamping.
Retain instructions for future reference.
Overview:
Low voltage track lighting fixture with 50 or 75 watt electronic
transformer for use with WAC “JT” series track.
Fixture may also be compatible with other manufacturer’s brand of
track (consult factory for compatibility).
Lamping:
JHT-874-LENS uses a 12v MR16 lamp, 50watt max.
JHT-874L-LENS uses a 12v MR16 lamp, 75watt max
1. Look through the open side of the fixture and align the pins of
the lamp with the holes in the socket.
2. Gently push the front edges of the lamp until you feel it seat in
the socket holes.
Accessories
:
Fixture accepts up to two accessories. The check ring may be
removed and an accessory lens and/or louver can be inserted
into the form fitting recess. Accessory combinations could be a
dichroic lens with honeycomb louver, colored lens with cross
baffle louver, etc.
1. Once the retaining ring has been removed, unscrew the
check ring.
2. Place the new lens or louver into the recess and re-install the
check ring.
Fixture Installation:
1. Note the track has a groove running its length to indicate polarity.
2. Note the arrow on the locking tab.
3. Insert adapter into track slot and rotate it 90° . The arrow should point to the grooved side of
the track.
4. Make sure the locking tab seats in the track slot.
5. Removal is the reverse procedure. Track heads may be positioned anywhere along the track
length.
Retain these instructions for future service and adjustments
615 South Street, Garden City, NY 11530
Tel: [phone] Fax [phone]
www.waclighting.com
Check ring
Accessory
Retaining ring