Track Head Installation Sheet

INSTRUCTIONS Low Voltage Track Fixture
Model: LHT-874 LHT-874L
Caution:
Read all instructions before installing.
Switch off power before installing or re-lamping.
Do not attempt to energize anything other than a track light fixture.
All installation shall be in accordance with NEC and all local codes.
To reduce the risk of a burn during re-lamping, remove from the track before re-lamping.
Retain instructions for future reference.
Overview:
Low voltage track lighting fixture with 50 or 75 watt electronic
transformer for use with WAC “LT” series track.
Fixture may also be compatible with other manufacturer’s
brand of track (consult factory for compatibility).
Lamping:
HHT-874 uses a 12v MR16G lamp, 50watt max.
HHT-874L uses a 12v MR16G lamp, 75watt max
1. Look through the open side of the fixture and align the
pins of the lamp with the holes in the socket.
2. Gently push the front edges of the lamp until you feel it
seat in the socket holes.
Retain these instructions for future service
and adjustments
615 South Street, Garden City, NY 11530
Tel: [phone] Fax [phone]
www.waclighting.com
Fixture Installation:
1. Note the track has a ridge running its length to indicate polarity.
2. Note the slant of the locking tab.
3. Insert adapter into track channel and rotate it 90º so that the low side of the locking tab faces the
ridged side of the track.
4. Make sure the locking tab seats in the track channel.
5. Removal is the reverse procedure. Track heads may be positioned anywhere along the length of
track.
Note: “LT” series track accepts only W.A.C. track heads.