Track Head Installation Sheet

INSTRUCTIONS Low Voltage Track Fixture
Model: HHT-874 HHT-874L
Caution:
Read all instructions before installing.
Switch off power before installing or re-lamping.
Do not attempt to energize anything other than a track light fixture.
All installation shall be in accordance with NEC and all local codes.
To reduce the risk of a burn during re-lamping, remove from the track before re-lamping.
Retain instructions for future reference.
Retain instructions for future reference.
Fixture Installation:
1. Note the track head contacts, and the polarity groove running the length of the track.
2. The two contacts should be positioned so that when rotated, they will face the grooved side of
the track (this is the side with two flat copper wires running it’s length).
3. Insert adapter into track slot. Rotate the adapter 90º.
4. Center the locking tab until is seats in the track slot.
5. Removal is the reverse procedure. Tracks may be positioned anywhere along the track length.
6. Not suitable for use on wall mounted track.
Overview:
Low voltage track lighting fixture with 50 or 75 watt electronic
transformer for use with WAC “HT” series track.
Fixture may also be compatible with other manufacturer’s
brand of track (consult factory for compatibility).
Lamping:
HHT-874 uses a 12v MR16G lamp, 50watt max.
HHT-874L uses a 12v MR16G lamp, 75watt max.
1. Look through the open side of the fixture and align the
pins of the lamp with the holes in the socket.
2. Gently push the front edges of the lamp until you feel it
seat in the socket holes.
Retain these instructions for future service and adjustments
615 South Street, Garden City, NY 11530
Tel: [phone] Fax [phone]
www.waclighting.com