Instructions

06/05/06
Step 3
Step 2
INSTRUCTIONS: Line Voltage Track Fixture
Model: HTK-104
Caution:
Read all instructions before installing.
Switch off power before installing or re-lamping.
Do not attempt to energize anything other than a track light fixture.
All installation shall be in accordance with NEC and all local codes.
Overview:
Fixtures are designed for use on “H” series W.A.C. Lighting track. They may also be used on other
manufacturer’s brand of track (consult factory for compatibility).
Installing on Track:
1. Note the track head contacts, and the polarity groove running the
length of the track.
2. The two contacts should be positioned so that when rotated, they
will face the grooved side of the track (this is the side with two
flat copper wires running its length).
3. Insert adapter into track slot. Pull downward on the adapter while
rotating the adapter 90º.
4. Release the adapter so the locking tab seats in the track slot.
5. Removal is the reverse procedure. Tracks heads may be
positioned anywhere along the track length.
6. Not suitable for use on wall mounted track.
Retain instructions for future reference.
Installing Lamp & Shade:
1. Fixture is supplied with a 120 volt MR16
lamp with GU10 base, 50Watt maximum.
(Not suitable for other types of lamps.)
2. Insert lamp into the shade so the lamp pins
protrude through the back.
3. Place pins in the socket holes and twist
1/4" to the right. The lamp should feel firmly
seated.
4. Seat the lamp under the “V” spring of the
gimbal ring.