Specifications

12/13/02 REV 1
12/13/02 REV 1
INSTRUCTIONS: Model: QP-902 Pendant Socket Set
Read all instructions before installing.
Disconnect power before installing or re-lamping
.
Overview: Pendant sockets sets are designed
for use with all WAC quick connect adapters.
They may also be used on other manufacturers
brand of quick connect (consult factory for
compatibility). Pendants may be mounted to
monorail, monopoints, line volt flexible track or
standard line volt track, by coupling to a low
voltage quick connect adapter. Sockets are
supplied with a 6′cable and may be field cut to
desired length.
Installing Lamp & Shade:
1. Insert lamp 12V 50W max. bi-pin Xenon,
(not tungsten halogen) into the socket (
supplied with 12V, a 24 volt lamp may
also be used with appropriate power
supply).
2. Remove the quick connector adapter
(see shortening pendant).
3. The small collar travels any where along
the length of the socket shaft and is
secured by a setscrew. This allows
varying lamp positions inside the shade.
Set the collar to a desired height.
4. Lower the shade until it rests on the
finial.
5. Re-install the quick connect adapter. If
shortening the pendant do this before re
installing (see shortening pendant).
Installing Pendant to Quick Connect:
1. Insert the post of the quick connect into
the quick connect adapter.
2. Thread the top half of the conical section
until it seats with the adapter.
3. Adjust fixture position, use caution not to
loosen the conical section.
Accessories: series G913, G914,G915, and
G918 glass shades.
See reverse for field shortenin
g
p
endants.
Pendant cable
Socket shaft
Collar
Setscrew
Shade
Socket
Xenon lamp
Installing to Quick Connect
Quick connect adapter
Top Conical section