Instructions

05/05/05 Rev 1
Field Cutting Rail:
1. Rail may cut to length in field.
2. Use fine-toothed hacksaw or heavy-duty bolt
cutter.
3. Thoroughly clear away all cutting debris.
4. Inspect end to insure the insulator has not
been damaged and there are no sharp edges.
5. Re-install track end cap.
Installing Fixtures:
Note: Fixtures attach to the rail with a two-piece
adapter. It is important that the setscrews of the
adapter all face the same way. This reduces the
possibility of an electrical short.
1. Using a 5/32” Allen wrench (supplied), loosen
the setscrew enough to allow adapter halves to
slip over mono rail.
2. Seat the adapter notches to the rail and tighten
the setscrew.
3. Inspect the rail to see that the adapters are firm
against it.
4. If the adapter is the quick connect type, thread
the quick connect adapter by screwing clockwise
until snug.
Important: observe polarity, install rail adapters with screws facing the same side of the
rail.
Important: Set-screws on adapters should all face the same direction