Installation Instructions-Quick Connect Canopies

2/11/03 REV 1
INSTRUCTIONS: Quick Connect Canopies
Models: QMP-M1RN and QMP-G1RN
CAUTION:
Always turn off power at fuse box prior to installation to prevent electrical shock.
For installation by a qualified electrician.
Line voltage wire must be 12awg BX or Romex wire.
Install over a standard 4 inch junction box.
All wires must be contained in the junction box.
Retain instructions for future reference.
Overview: Canopies are designed to fit all
W.A.C quick connect fixtures. They may also
be used on other manufacturers brand of
quick connect (consult factory for
compatibility). Uses a 50 watt max fixture or
pendant.
Canopies come with self-contained electronic
transformers that can generally be used with
standard incandescent dimmer switches.
1. Loosen the three canopy screws and
separate the canopy from the base plate.
2. Remove a knock out from the base plate.
3. Support canopy and guide the black and
white wires and from the transformer
through the knock out in the base plate
and into the Junction box.
4. Connect ground wire from junction box to
the green grounding wire from the base
plate.
5. Connect corresponding line volt wires
from the junction box to transformer
wires, with wire nuts (supplied). Tuck
excess wire into the junction box.
6. Attach the base plate to the junction box
using the slotted holes.
7. Raise the canopy to the base plate, and
tighten the three screws loosened earlier.
Junction Box
Base Plate
Ground wire
Canopy
Quick Connect Fitting
Finishing ring
Shown with QF-194
Fixture (not included)