Assembly Instructions

09/01/06 Rev 1
INSTRUCTIONS: Model: QF-184 Fixture
INSTRUCTIONS PERTAINING TO A RISK OF FIRE,
OR INJURY
Lighted lamp is HOT!
WARNING- To reduce the risk of FIRE OR INJURY:
Turn off all power and allow to cool before replacing
lamp.
Lamp gets HOT quickly! Contact only switch/plug when
turning on.
Do not touch lens, guard, or enclosure.
Keep away from materials that may burn.
Do not touch the lamp at any time. Use a soft cloth. Oil
from skin may damage lamp.
Do not operate the luminaire with a missing lens or
damaged shield.
Save these instructions.
Overview: Fixtures are designed for use with all WAC
quick connect adapters. They may also be used on
other manufacturers brand of quick connect (consult
factory for compatibility).
This fixture may be mounted to Monorail, Monopoints,
Flexrail2, Linear, or standard track, by coupling to a
female quick connect adapter.
The fixture is compatible with various metal and glass
shade choices (see below).
Installing lamp & Shade:
1. Place the lamp inside the shade so the two pins
protrude through the back. Insert the lamp into
the fixture by aligning the pins with the socket
holes, and gently pushing until lamp seats.
2. Use an MR16-G (glass covered lamp) 75 watt
max (12 or 24 volt depending on power supply).
3. Note: Fixture may also be used with 50W
Xenon bi-pin lamp.
Installing the quick connect:
1. Insert the post of the quick connect into the
quick connect adapter.
2. Thread the top half of the conical section until it
seats with the adapter.
3. Adjust fixture position, use caution not to loosen
the conical section.
Accessories:
Accepts glass or metal shades from the G100 series.
2.
Quick Connect Adapter
Top Conical Section
Shown above with the G119 shade
MR16 lamp
Socket
Spring band