Installation & Assembly

6WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. OCTOBER, 2016
waclighting.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
AIMING THE FIXTURE:
Loosen the Set Screws and Rotating Arm Screw to aim the xture
head to desired position before retightening the screws.
BEAM ANGLE ADJUSTMENT:
Note the four pre-determined beam angles on the beam angle
changing dial.
Use the provided Hex Key to slightly loosen the screw.
Do not remove screw from xture.
CAUTION: The set screw should either be inset or ushed with the
surface of the xture. Do not extrude out and remove from the
xture at any time. It should only be taken out for xture servicing.
Consult factory for service instruction.
Rotate the dial until the arrow is aligned with the desired
beam angle. This beam angle may either be one of the
pre-determined ones or any number in between.
Tighten the set screw that is located on the beam angle dial to lock
the dial in place.
ACCESSORIES:
Lens Accessory:
Frosted, red, blue, green and amber lense accessories are used
to alter the spectrum and distribution of the light coming out of
the xture.
Installation: Place the lens in between the xture and
the shroud. Tighten the thumb screw on the shroud to
secure the lens in place
Set Screw
Set Screw
Set Screw
Hex Key
Beam Angle Dial
LENS-20-
Thumb Screw
Rotating Arm Screw
360°
360°
±90° from Vertical
INSTALLATION INSTRUCTION
Adjustable Spot - Endurance Sign Lighting
WP-LED514, WP-LED529
10˚
25˚
40˚
60˚