Installation Instruction

INSTALLATION INSTRUCTION
Quick Adjust™ Pendant Canopy
PENDANT INSTALLATION
1. Make the desired cut of the “braided cord” for proper mounting height. Trim 1/8” of insulation from the inner wire.
2. Feed the “braided cord” through “canopy nut” and “canopy cover”. Push up the “cable grip” top and feed the braided cord until
3” braided cord comes out from side hole.
3. Position the “side collar” (supplied) so that a small section (1/16”) of “braided cord” protrudes from the top of the collar.
4. Feed the “braided cord” and “side collar” into the end of the “wire ring” and tighten the set screw with allen wrench (supplied).
5. Use wire nuts (supplied) to connect the protruding braid cord to the wire coming from the transformer.
6. Raise the “canopy cover” and make sure that wires are contained in the “canopy cover”.
7. Tighten “canopy nut”.