Installation Instruction

INSTALLATION INSTRUCTION
Quick Adjust™ Pendant Canopy
SAFETY INSTRUCTION
• Do not conceal or extend exposed conductors through a building wall.
• Do not install this system in wet locations.
• To reduce the risk of re and burns, do not install this lighting system where the exposed bare conductors can be shorted or
contact any conductive materials.
• Make sure all connections are tight.
• Do not install any luminaire closer than 6 inches from any curtain, or similar combustible materials.
• Turn o electrical power before modifying the lighting system in any way.
• Install over a standard 4 inch junction box.
1. Unscrew “canopy nut” and remove “canopy cover”
from the threaded cable grip.
2. Pull down the “insulation plate”.
3. Support canopy and guide the black and white
wires from the transformer into the junction box.
4. Connect ground wire from junction box to the
green grounding wire from the base plate.
5. Connect corresponding line volt wires from the
junction box to transformer wires (white wire connect
to white wire and black wire connect to black wire),
with wire nuts (supplied). Tuck excess wire into the junction box.
6. Attach the “base plate” to the junction box using
the slotted holes and screws.
7. Re-attach “insulation plate”.
OVERVIEW
The canopy designed to t all Pendants. Uses a 50 watt max halogen lamp. The pendant weight should be no more than 5
pounds. The canopy comes with a self-contained electronic transformer that may be dimmed with an electronic low voltage
dimmer switch.