Installation Instruction

ManualsBrandsWAC Lighting ManualsLightingHaven Quick Connect Pendant

cording to the step1,2,3, shown with picture below)

INSTALLING SHADE:

1.Position Socket Set so that threads through the hole in the shade

and screw on Ring from below by nger or Ring Tool.

(See diagram).

For model

1. Put the knitted cable from the Socket Set into the cable grip(ac-

FOR MODEL

1. Insert the post of the quick connect into the quick connect adapter.

2. Thread the top half of the conical section until it seats with the adapter.

3. Adjust xture position, use caution not to loosen the conical section

INSTALLATION INSTRUCTION

LED Quick Connect™ Socket Set

Summary of content (4 pages)

PAGE 1
INSTALLATION INSTRUCTION LED Quick Connect™ Socket Set INSTALLING SHADE: 1.Position Socket Set so that threads through the hole in the shade and screw on Ring from below by finger or Ring Tool. (See diagram). For model 1. Put the knitted cable from the Socket Set into the cable grip(according to the step1,2,3, shown with picture below) FOR MODEL 1. Insert the post of the quick connect into the quick connect adapter. 2. Thread the top half of the conical section until it seats with the adapter. 3.
PAGE 2
INSTALLATION INSTRUCTION LED Quick Connect™ Socket Set TO INSTALL / SHORTEN THE CABLE: Feed the cable end through the Top Conical section and the metal finial. If cable needs to be shortened, make the cut now. To install the top conical section, follow the step-by-step instructions bellow. NOTE: Pendant cables are co-axial, if the lower screw in step 4 is made too tight, the inner an outer wire will short. A short circuit will render the entire system in-operative and possibly damage the transformer.
PAGE 3
INSTALLATION INSTRUCTION Quick Adjust™ Pendant Canopy SAFETY INSTRUCTION • Do not conceal or extend exposed conductors through a building wall. • Do not install this system in wet locations. • To reduce the risk of fire and burns, do not install this lighting system where the exposed bare conductors can be shorted or contact any conductive materials. • Make sure all connections are tight. • Do not install any luminaire closer than 6 inches from any curtain, or similar combustible materials.
PAGE 4
INSTALLATION INSTRUCTION Quick Adjust™ Pendant Canopy PENDANT INSTALLATION 1. Make the desired cut of the “braided cord” for proper mounting height. Trim 1/8” of insulation from the inner wire. 2. Feed the “braided cord” through “canopy nut” and “canopy cover”. Push up the “cable grip” top and feed the braided cord until 3” braided cord comes out from side hole. 3. 4. 5. 6. 7. Position the “side collar” (supplied) so that a small section (1/16”) of “braided cord” protrudes from the top of the collar.