Installation Sheet

INSTALLATION INSTRUCTION
GEMINI 300
T24-GE3
waclighting.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Ave
Ontario, CA 91761
WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. January 2022 2.
2.1) Power Supply: PS-24DC-U60R-BT & PS-24DC-U96R-BT
To extend the cable length between hard wire power supply or a wiring box to a tape sections, an extension cable (T24-BS-EX2-*) is needed.
The extension cable package also provides small screw driver to unscrew the connector.
Wire Color
Power Supply
Output
T24-BS-EX2-* Cable
Tape
marking
RED RED +24VDC
BLACK BLACK -
Extension Cable (T24-BS-EX2-*) and Low Voltage Wiring Box (LED-T-
B) can be used to join between wires.
2.2) Power Supply: EN-BT60-24 & EN-BT96-24
This power supply has pre-installed output 6ft lead wire. 24VDC Extension Cable (T24-BS-EX2-*) and Low Voltage Wiring Box (LED-T-B) can
be used to join between wires and extend the output lead length.
3. Measure the desired length of tape light and round it off to the
nearest 4-inch interval. Determine necessary quantities of
other accessories and power supply need for each run. Do
not exceed maximum run recommended for each tape series
4. If necessary, cut tape light to desired length at line indicated
The tape allows for a cut every 2-inch interval.
5. Mount Tape Light: Clean surface before mounting. Peel off 3M adhesive backing cover off as strip is installed, pressing firmly to mounting
surface in increments.
6. Joining between tapes:
LED-T-B
T24-BS-EX2-*
25ft. Max