Installation Sheet

INSTALLATION INSTRUCTION
GEMINI 300
T24-GE3
waclighting.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Ave
Ontario, CA 91761
WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. January 2022 3.
Joining tape together (If needed), the following accessories can be used to join between tapes section depending on your application:
Tape to Tape Connector (T24-BS-MM) – Making sure that voltage polarity connection is match between tapes.
Joiner Cable (T24-BS-IC-*) can be used to join between tape sections – the wire insulation jacket shall be stripped. Make sure that voltage
polarity connection matches between tapes.
Wire Color
Power Supply Output T24-BS-IC-* Cable Tape marking
RED RED +24VDC
BLACK BLACK -
Flex Y Connector (T24-BS-Y) – the wire insulation jacket shall be stripped, Make sure polarity matches between tapes.
Flex X Connector (T24-BS-X) – the wire insulation jacket shall be stripped, Make sure polarity matches between tapes.
Flex X & Y Connector can be used for power feeding by using low voltage wiring box (LED-T-B).
Make sure that polarity is correct.