Installation Sheet

waclighting.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Ave
Ontario, CA 91761
WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. SEPT. 2020 3.
INSTALLATION INSTRUCTION
InvisiLED
®
CCT 100/200/300/400/600
T24-CS
To extend the cable length between power supply cable or a wiring box to a tape sections, (if needed), In Wall
Rated Extension Cable (T24-EX3) can be used to join between sections by soldering as shown below:
Wire Color
CCT Power Supply Output
T24-EX3 Cable
Tape marking
RED
RED
+24VDC
BLACK
BLACK
-5000K
BLUE
WHITE
-2700K
3. Measure the desired length of tape light and round it off to the nearest 4-inch interval. Determine necessary
quantities of other accessories and power supply need for each run. Do not exceed maximum run
recommended for each tape series
4. If necessary, cut tape light to desired length at line indicated with scissors icon. The tape allows for a cut
every 4-inch interval. The cut line is shown on both sides of connector.
5. Mount Tape Light: Clean surface before mounting. Peel off 3M adhesive backing cover off as strip is installed,
pressing firmly to mounting surface in increments.
T24-FF-WT
T24-EX3
Peel back during
installation
Adhesive back cover