Installation Sheet

waclighting.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Ave
Ontario, CA 91761
WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. June 2020 5.
INSTALLATION INSTRUCTION
BASICS 100/200
T24-BS
24VDC Basics Flex X & Y Connector can be used for power feeding by using low voltage wiring box (LED-T-B).
Making sure that polarity is correct.
7. Connect electrical power feed wires to 24VDC Basics Inline Power to Tape Connector (T24-BS-PM-CL) with tape.
Making sure that polarity is correct. The wire insulation jacket shall be stripped.
Wire Color
Power Supply Output
T24-BS-PM-CL Cable
Tape marking
RED
RED
+24VDC
BLACK
BLACK
-
Hard Wire:
• Enclosed 24VDC class 2 output remote power supply must be installed away from any heat sources and it
must be accessible for service.
• Enclosed 24VDC class 2 output remote power supply is UL listed.
• The power supply box has a separate line voltage, and low voltage wiring compartments.
• Trade size knock out are provided on both compartments. Connect building wires to the same color power
supply wires with wire nuts or UL certified electrical connector.
• Building ground wire may be green or uninsulated, and attaches to green wire from power supply box.
• Additional power feeds and wiring components are available.
Portable:
• 24VDC class 2 output plug-in power supply plugs into standard 120VAC volts 2 prong grounded outlet.
• Power Supply must be installed away from the heat sources.
T24-BS-EX2
LED-T-B