Installation Sheet

waclighting.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Ave
Ontario, CA 91761
WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. June 2020 3.
INSTALLATION INSTRUCTION
BASICS 100/200
T24-BS
2.2) Power Supply: EN-BT60-24, EN-BT96-24
This power supply provides a 6 foot output leads wires. To extend the cable length between hard wire power
supply or a wiring box to a tape sections (if needed), 24VDC Basics Extension Cable (T24-BS-EX2) and Low
Voltage Wiring Box (LED-T-B) can be used to join between wires.
The maximum distance between power supply to the beginning of the tape is 40ft.
3. Measure the desired length of tape light and round it off to the nearest 4-inch interval. Determine necessary
quantities of other accessories and power supply need for each run. Do not exceed maximum run recommended
for each tape series
4. If necessary, cut tape light to desired length at line indicated with scissors icon. The tape allows for a cut every 4-
inch interval.
5. Mount Tape Light: Clean surface before mounting. Peel off 3M adhesive backing cover off as strip is installed,
pressing firmly to mounting surface in increments.
6. Joining between tapes:
Joining tape together (If needed), the following accessories can be used to join between tapes section
depending on your application:
24VDC Basics Inline Tape to Tape Connector (T24-BS-MM-CL) – Making sure that voltage polarity connection
is match between tapes.
EN-BT60-24
6 ft long