Specification Sheet

Fixture Type:
Catalog Number:
Project:
Location:
WAC Lighting
www.waclighting.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Avenue • Ontario, CA 91760
Phone [phone] • Fax [phone]
WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. MAY 2015
CONNECTION ACCESSORIES
"I" Connector SL-I
Ø4" × d"
For end-to-end connection of fixtures.
(One included with each fixture).
Joiner Cables
SL-IC-06
SL-IC-12
SL-IC-24
SL-IC-36
6”
12”
24”
36”
Connects two sections of luminaires.
Custom Cable Extenders
SL-IF
Øa" × 3s"
Two female ends.
Connects two joiner cables to create custom lengths.
4-way "X" connector
SL-X
Wires: 4" each
Connectors: 18" each
"X" connector has four male connectors and can
be used to easily customize your design layout.
3-way "Y" connector
SL-Y
Wires: 4" each
Connectors: 18" each
"Y" connector has three male connectors and can
be used to easily customize your design layout.
POWER SUPPLY ACCESSORIES
Wiring box with switch
TBS
64” × 1s” × 14”
Use when spanning a large gap in a system layout
without leaving exposed wiring (ie: lighting kitchen
cabinets on both sides of a sink or window).
Low voltage wiring is collected inside box,
with Romex® wire output to go behind a wall.
Multiple Terminal Block
MTB06
MTB08
6 outputs
8 outputs
4d” × 1s” × w”
4d” × 1s” × w”
Easily wire multiple output connections for a
neat installation without the use of open splices.
One power supply input and either 6 or 8 outputs.
5A capacity. Three mounting screws included.
12' Extension Cable
SL-EXT-144
Wire: 144"
Connector: 18"
Use to extend the distance between power supply
or wiring box (TB-S) to a fixture.
Wire Clip (10 Pack)
SL-WC-1
2" × a"
Use to tack power cords or joiner cables
neatly to a surface.
Under Cabinet Task Luminaire
Accessories