Installation Sheet

WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. APRIL, 2015 2
WAC Lighting
www.waclighting.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
PREPARATION
- Shut off the power at the circuit breaker and remove existing fixture, including the mounting hardware.
- Carefully unpack your new fixture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
MOUNTING THE FIXTURE FIG. 1
1. Remove mounting plate screw (C1) from fixture, remove wire connectors (D1)
CONNECTING THE WIRES FIG. 2
2. Connect the driver input wires to supply wires as shown in Fig. 2, using wire connectors (A1). Make sure that all wire connectors (A1)
are secured. If your outlet box has a green or bare copper ground wire, connect the fixture’s ground wire. Otherwise, connect the fixture’s
ground wire directly to the mounting plate using the green screw provided. After wires are connected, tuck them carefully inside
the junction box.
*Requires driver to be recessed within the junction box.
MOUNTING THE FIXTURE FIG. 1
3. Secure the mounting plate to the junction box using
the junction box screws (B1).
The side of the mounting plate marked “GND” must face out.
4. Connect the driver output wires to the fixture wires,
secure with wire connectors (D1).
5. Place the mounting canopy over the mounting plate
and secure with the mounting plate screws (C1).
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig. 2
Fig. 1
Junction Box
Power input wire
Ground wire
Driver
Mounting plate
Wire Connector
Wire Connector
Output Wire
Canopy
Junction Box Screw
Mounting Screw
D1
C1
B1
A1
INSTALLATION INSTRUCTION
Vector - LED Track Kit (Single)
MO-495