Installation Guide

WAC Lighting
www.waclighting.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. JUNE, 2014
INSTALLATION INSTRUCTION
InvisiLED® Indoor Controller
LED-TC-CTR-MSD
DMX CONTROLLER
Set the switch to DMX to run the controller under DMX control. Each controller box needs to be set to DMX. The buttons on the
box will have no function after connecting with DMX. The DMX system will start to work.
DMX ADDRESSING
When using a DMX controller, each box needs a DMX starting address in order to respond to the correct control signal coming
from the DMX controller. To allocate a DMX starting address, combine various dip switches that represent binary values.
Find the shortest path to the DMX value for correct address assignment.
Example:
DMX Address 001 = Dip Switch 1”ON”=Binary value 1
DMX Address 009 = Dip Switches 1and 4”ON”=Binary value 9
DMX Address 087 = Dip Switches 1, 2, 3, 5, 7”ON”=Binary value 87
Math 1+2+4+16+64=87
MASTER CONTROLLER
Set switch on the controller to the Master location for the controller to be used as the Master Controller. The buttons will function
to adjust the tape light. To operate under remote control, please refer to the remote control instruction sheet.
Slave Controller
Set the switch to the Slave position for the controller to have slave function only; following the Master Controller.
The buttons on the box will have no function.