Installation Guide

WAC Lighting
www.waclighting.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. JUNE, 2014
INSTALLATION INSTRUCTION
InvisiLED® Indoor Controller
LED-TC-CTR-MSD
FUNCTION OF BUTTONS:
1. Brightness Adjustment Button: Push the (up) and  (down) buttons on the column to adjust the total brightness
of the INVISILED® tape light. There are 10 steps for the brightness level; the dimming range is from 100% to 0.
Dim to 0 to turn power o.
2. Color Changing Speed Button: Push the (faster) and (slower) buttons on the * column to adjust the color transition
speed of the INVISILED® tape light. There are 10 steps for the color transition. When the speed reaches its maximum or
minimum level, these buttons are invalid.
3. Blue Indicator light: indicates button is functioning when pushed.
4. Pause and Play Button: Pushing the button xes the color of the INVISILED® tape light
at any point during the color transition.
5. Color Button: Push the “COLOR” button to switch between RGB light and white light.
6. Red Indicator light: When lit, the 24V DC power supply is plugged in.
CONTROLLER PUSH BUTTONS:
SAMPLE LAYOUT
A EN2460DCP PLUG IN POWER SUPPLY
B LEDTCCTRMSD INDOOR CONTROLLER
WITH DMX
C LEDTO24WS PALETTE WIRELESS
CONTROLLER
D LEDTC24SW60 PALETTE SIGNAL WIRE
E LEDTCX X CONNECTOR
F LEDTCY Y CONNECTOR
G LEDTCIC72 6 FOOT JOINER CABLE
H LEDTC1RGB 1 FOOT PALETTE TAPE
SECTION
I LED TC5RGB 5 FOOT PALETTE TAPE
SECTION
J LEDTCEC END CAP