Installation Guide

WAC Lighting

www.waclighting.com

Phone (800) 526.2588 • Fax (800) 526.2585

Headquarters/Eastern Distribution Center

44 Harbor Park Drive • Port Washington, NY 11050

Phone (516) 515.5000 • Fax (516) 515.5050

Western Distribution Center

1750 Archibald Ave • Ontario, CA 91761

Phone (800) 526.2588 • Fax (800) 526.2585

WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. JUNE, 2014

INSTALLATION INSTRUCTION

InvisiLED® Indoor Controller

LED-TC-CTR-MSD

KEY SPECIFICATIONS:

Overall dimensions: 3 11/16” x 2 1/4” x 1” (94mm x 57mm x25mm)

Min/max run length: Under 24V 60W DC power supply, it can control 40ft of INVISILED® Palette.

Power Supply: 24V DC power supply, Class II

Current: 4.2A Maximum

Application: Intended for indoor use, in dry or damp locations.

The recommended ambient environment temperature is −4ºF to 122ºF, and relative humidity up to 95%. Suggested for use with

refrigerated food or beverage cabinets; bar and counter accent; under cabinet task lighting; toe kick accent lighting; display cases

and windows; trade show booths; architectural coves; audio/visual accents.

CONTROLLER PUSH BUTTONS:

PAGE 1
INSTALLATION INSTRUCTION InvisiLED® Indoor Controller LED-TC-CTR-MSD KEY SPECIFICATIONS: Overall dimensions: Min/max run length: Power Supply: Current: 3 11/16” x 2 1/4” x 1” (94mm x 57mm x25mm) Under 24V 60W DC power supply, it can control 40ft of INVISILED® Palette. 24V DC power supply, Class II 4.2A Maximum Application: Intended for indoor use, in dry or damp locations. The recommended ambient environment temperature is −4ºF to 122ºF, and relative humidity up to 95%.
PAGE 2
INSTALLATION INSTRUCTION InvisiLED® Indoor Controller LED-TC-CTR-MSD FUNCTION OF BUTTONS: 1. Brightness Adjustment Button: Push the (up) and  (down) buttons on the column to adjust the total brightness of the INVISILED® tape light. There are 10 steps for the brightness level; the dimming range is from 100% to 0. Dim to 0 to turn power off. 2. Color Changing Speed Button: Push the (faster) and (slower) buttons on the * column to adjust the color transition speed of the INVISILED® tape light.
PAGE 3
INSTALLATION INSTRUCTION InvisiLED® Indoor Controller LED-TC-CTR-MSD MASTER CONTROLLER Set switch on the controller to the Master location for the controller to be used as the Master Controller. The buttons will function to adjust the tape light. To operate under remote control, please refer to the remote control instruction sheet. Slave Controller Set the switch to the Slave position for the controller to have slave function only; following the Master Controller.