Installation Sheet

WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. JULY, 2016 7
waclighting.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Factory
44 Harbor Park Drive
Port Washington, NY 11050
Central Factory
1600 Distribution Ct
Lithia Springs, GA 30122
Western Factory
1750 Archibald Avenue
Ontario, CA 91760
INSTALLATION INSTRUCTION
Indirect Recessed Channel
LED-T-RCH3-WT
6. Mark a 4 3/8” x 3” rectangle on the drywall where the junction box will be located.
Cut out the marked rectangle using a jabsaw or “Rotozip” tool.
Mount the drywall to the studs.
Using the drywall opening as reference, mark 4 3/8” wide lines and cut the desired length of the channel along the drywall.
Mark the location of the Studs for later use.
In any cases where no stud/joist is present, LED-T-CH-PER may be used to secure the channel to the dry wall.
Mount LED-T-CH-PER with two #8 Wood Screws 5” apart centered around the cutout. LED-T-CH-PER should be spaced in 2 feet.
Centerline
4 3/8”
Cutout
Studs
1/2” Thick Drywall
2 ft TYP
Drywall Cutout
Mark Center of
LED-T-CH-PER
LED-T-CH-PER
LED-T-CH-PER
(Perfoated Metal Sheet)
#8 Wood Screws
(Provided)
3”