Installation Sheet

WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. JULY, 2016 12
waclighting.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Factory
44 Harbor Park Drive
Port Washington, NY 11050
Central Factory
1600 Distribution Ct
Lithia Springs, GA 30122
Western Factory
1750 Archibald Avenue
Ontario, CA 91760
12. Pull out the LED-TC-B-2L from Junction Box.
Plug the Tape Light Strip into the Wire Connector.
Tuck the wire connector back to the junction box.
Removing the backing from the tape light strip and install it inside the channel by using your ngers or the provided tool LED-T-CH-INS.
Make sure to push the connector as close to the end of the channel as possible to eliminate dark spot at the beginning of the run.
Make sure that the tape light strip is rmly attached to the channel.
Note: There are two positions for installing the tape light strips.
Tape light strips can be installed at either position.
Or two strips can be installed at the same time.
After trimming the tape light strip on cuttable section, place the excess strip behind the drywall through the End Cap Opening.
INSTALLATION INSTRUCTION
Asymmetrical Recessed Channel
LED-T-RCH2-WT
LED-RC-B-2L LED-T-CH-INS
Excess Strip
End Cap
Opening
Tape Light Strip
Tape Light Strip
Must be installed here