Installation Guide

WAC Lighting
www.waclighting.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. MAY, 2014
INSTALLATION INSTRUCTION
24V LED Button Lights - round
HR-LED87
CAUTION :
TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK AND INJURIES TO PERSONS:
• Use only insulated staples or plastic ties to secure cords.
• Route and secure cords so they will not be pinched or damaged when cabinet is pushed to the wall.
• Not intended for recessed installation in ceilings.
• Use 24V WAC Class 2 transformer.
RECESS MOUNT
1. Cut a 2 1/8” diameter hole on the surface.
2. The decorative cover piece is not needed for
recessed mounting, and may be discarded.
3. Feed the xture wires through the hole, and connect
to wires from the transformer with wire nuts provided.
4. Compress the springs on either side of the xture
and insert into the opening.
SURFACE MOUNT
1. Wires may be run behind the xture or along a surface.
Determine the most convenient location for wire passage.
The “D” shaped knock out hole in the cover piece allows wire
to exit and run along a surface.
To wire behind the xture, drill a hole in the surface sucient
to allow the socket wires through. Punch the knock out in the
cover piece and align with the hole.
2. Screw the cover piece to the surface with screws provided.
3. Feed the xture wires through the hole, and connect to wires
from the transformer with wire nuts provided.
4. Compress the springs on either side of the xture and
insert into the back cover.
CLASS 2 WIRING:
Cabinet xtures require 24V Class 2 transformers. Class 2 transformers are by denition “Power limited” (5 amps maximum) and
“Inherently Protected” (fused). Primary wires to the transformer enclosure must follow normal NEC chapter 3 wiring techniques.
Non enclosed secondary wiring and splices are not restricted in concealed spaces.