Installation Sheet

WAC Lighting
www.waclighting.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. JUNE, 2014
INSTALLATION INSTRUCTION
Rubix - LED Ceiling Mount
FM-W2505
PREPARATION
1. Shut o the power at the circuit breaker and
remove existing xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the
parts on a clear area. Be careful not to lose any small
parts necessary for installation.
MOUNTING THE FIXTURE (Fig. 1)
3. Secure mounting plate (C1) to the junction box (A1)
using junction box screws (D1).The side of the
mounting plate marked “GND” (C1) must face out.
CONNECTING THE WIRES (Fig. 2)
4. Connect the electrical wires as shown in Fig. 2,
making sure that all wire connectors (B1) are secured.
If your outlet box has a green or bare copper ground wire,
connect the xture’s ground wire to it. Otherwise, connect
the xture’s ground wire directly to the mounting plate (C1)
using the green screw provided. After wires are connected, tuck
them carefully inside the junction box.
5. This xture may be dimmed with an electronic low voltage
dimmer switch or a 0-10V dimmer switch. If necessary, connect
the brown (BR or +) / blue (BL or -) wires of driver to the 0-10V
dimmer switch (not provided).
6. Place the xture over the mounting plate (C1) and secure
with screws (E1) and gasket (F1).
COMPLETING THE INSTALLATION (Fig. 3)
7. To prevent moisture from entering the outlet box and causing
a short, use clear caulking (i.e. indoor/outdoor silicone sealant)
to outline the outside of xture back plate where it meets the
wall leaving a space at bottom to allow moisture a means to
escape (Fig.3).
100%10% DIMMING
COMPATIBLE WITH THE FOLLOWING ELECTRONIC
LOW VOLTAGE ELV DIMMERS
LUTRON DVELV-300P ,SELV-300P
LEVITON VPE04,IPE04
A1
B1
C1
D1
E1
F1
FIG.1
FIG.2
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare Copper
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)