Installation Sheet
WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. Oct 2020
dweLED.com
Phone (800) 526.2588
Fax (800) 526.2585
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
2
INSTALLATION INSTRUCTION
FM-53116
1. Shut o the power at the circuit breaker and remove existing xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
3. Connect the xture wires with supply wires as shown in Fig. 2, making sure all wire connector(A) are secured. If your outlet box has a
green or bare copper ground wire, connect the xture’s ground wire to it. Otherwise, connect the xture’s ground wire directly
to the mounting plate using the green screw provided. After all wires are connected, tuck them carefully inside the junction box.
4. Secure mounting plate to the junction box using junction box screws .
The side of the mounting back plate marked “GND” must face out.
(i)using any other non-original-manufacturer provided junction box screw may result in safty issue.
(ii) The side of the mounting plate marked “GND” must face out.
5. Place the xture on the mounting back plate and secure it with
mounting screw (B).
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Mounting back plate
Mounting Screw
B
Fixture
Driver
Junction box
Ground Wire
Junction Box Screw
Wire Connector
A
2 3/4"
3 1/2"
9 7/8"
7"
Mounting Backplate Dimensions