Installation Sheet

WAC Lighting
www.waclighting.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. MAY, 2018 2
INSTALLATION INSTRUCTION
GLO
FM-211, FM-214, FM-216
Fig. 1
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig.2 Wiring
PREPARATION
1. Shut o the power at the circuit breaker and remove existing xture, including the mounting hardware.
2. Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts
necessary for installation.
CONNECTING THE WIRES (Fig. 2)
3.
Connect the fixture input wires to junction box wires as shown in Fig. 2, making sure that all wire connectors
are secured. If your outlet box has a ground wire (Green or bare copper), connect the fixture’s ground wire to it.
After wires are connected, tuck them carefully inside the junction box.
MOUNTING THE FIXTURE (Fig. 1)
4.
Remove the diffuser from the base plate by twisting it
counter-clockwise.
Discard the foam spacer and secure the base plate to
the junction box using the junction box screws provided.
7.
Reinstall the diffuser onto the base plate by twist locking in
a clockwise direction.
5.
3", 4" or 3/0-4/0 electrical
box, (by others)
Wire Connector
Base Plate
Junction Box Screw
Diffuser
6.
Select the desired Color Temperature by setting the sliding switch
to the target CCT (See Fig. 3).
2700K
3000K
3500K
4000K
5000K
Fig. 3