Installation Sheet

2WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program.
waclighting.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
A1
B1
F 1
C1
D
1
E
1
FIG.1
Wire Connector
Mounting Plate
Plastic Anchor
Wood Screw
Nuts
Mounting Screw
Junction Box Screw
Fixture Base
Driver
Lamp Shade
INSTALLATION INSTRUCTION
166 - LED Flush Mount
FM-16617, FM-16622
PREPARATION
1. Shut o the power at the circuit breaker and remove existing xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
CONNECTING THE WIRES (Fig. 2)
3. Remove the mounting screw (F1) from the xture, take down the lamp shade.
4. Remove the nuts (E1) from the PCB board; take out the mounting plate.
5. Drill holes in the wall aligned with the key holes in the xture base, insert the plastic anchor (C1).
6. Secure the mounting back plate to the junction box using junction box screws (B1).The side of the mounting back plate marked “GND” must
face out.
7. Connect the Driver’s input wires to junction box wires as shown in Fig. 2, making sure that all wire connectors (A1) are secured. If your outlet
box has a green or bare copper ground wire, connect the xture’s ground wire to it. Otherwise, connect the xture’s ground wire directly to
the back plate using the green screw provided. After wires are connected, tuck them carefully inside the junction box.
MOUNTING THE FIXTURE (Fig. 1)
8. Secure the xture base to the mounting plate using nuts (E1),
fasten it to the wall using wood screw (D1).
9. Secure the lamp shade onto the xture base with mounting screw (F1).
Back Plate Dimensions
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig. 2 Wiring
1 3/4” 1 3/8”
Junction Box
4”
4”