Installation Sheet

INSTALLATION INSTRUCTION
Cube Architectural-LED Narrow Beam Wall Mount
DC-WS05-U, DC-WS06-U, DC-WD05-U, DC-WD06-U
WAC Lighting Headquarters/Eastern Distribution Center Western Distribution Center
www.waclighting.com 44 Harbor Park Drive • Port Washington, NY 11050 1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone] Phone [phone] • Fax [phone] Phone [phone] • Fax [phone]
WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program.
2 / 3
OVERVIEW
It is surface mount down light, included ceiling mount, pendant mount, single direction wall wash and up-down
direction wall wash. Check catalog for various mount type, size, beam angle and color choices.
FIXTURE INSTALLATION
1. Carefully unpack your new fixture and lay out all the parts on a clear area. Be carefully not to lose any small
parts necessary for installation. (See FIG.1)
2. Remove the screw holding mounting plate to fixture, and remove mounting plate from fixture. (See FIG.2)
3. Secure mounting plate to the junction box in wall provided by others. (See FIG.2)
4. Pull power supply wires out of junction box through mounting plate. Connect black fixture wire to hot wire, white
fixture wire to neutral wire and green fixture wire to ground. This fixture offers 0-10V dimming capability. T
o
utilize, connect purple fixture wire to hot dimming wire and gray fixture wire to neutral dimming wire. If not
utilizing dimming, terminate the dimming wires by capping them separately. After wires are connected securely,
tuck them carefully inside the junction box . (See FIG.2)
5. Put the fixture to the mounting plate, and secure with screws and gasket.(See FIG.2)
LED REPLACEMENT
1. Loosen the screw and gasket (See FIG.3), remove the panel assembly (See FIG.4).
2. Loosen the Lens holder and Lens, carefully disconnect LED connector from driver connector and replace LED by
removing LED mounting screws. (See FIG.5).
FIG. 2
Gasket
Screw
Mount plate
Junction box
Ground wire
FIG. 4
Remove panel
assembly
Lens holder
Lens
FIG. 5
LED
FIG. 3
Loosen the
screws and
gaskets
Screws