Installation Guide

WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program.
waclighting.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
INSTALLATION INSTRUCTION
Cube Architectural - Swivel Canopy Suspension Kit
DC-PDSK
3. Align the top of the cast ball with the top of the cut pendant stem and temporarily lock it in place by tightening one of the screws into
the side of the stem. Use the provided drill bit to drill a hole through the stem wall using the unthreaded hole.
4. Loosen the screw. Rotate the cast ball 180° and retighten the screw. Drill another hole using the unthreaded hole on the other side
of the stem wall.
5. Loosen the screw. Rotate the cast ball 90° and fully lock both screws through the two tap holes to secure the cast ball.
(Refer to Figures 5 and 6)
6. Align the pendant assembly- Refer to Figure 7
7. Pull power supply wires out of junction bo
neutral dimming wire. If not utilizing dimming, terminate the dimming wires by capping them separately. After wires are connected secure-
ly, tuck them carefully inside the junction box. Refer to Figure 8
8. Raise the canopy up and rotate clockwise until align the ceiling, then use a screwdriver to tighten the screw. Refer to Figure 9
Screw Drill hole
Screw
Cast ball
Drill
Screw hole
Screw hole
Feed wire
clamp
Junction box
(by others)
on
Wire connect
Mounting plate
Canopy
Mounting
Plate
Stem
Canopy
Washer
Fixture
Plate
Nut
Figure.5
Figure.7
Figure. 6
Figure. 8 Figure. 9