Installation Guide

Retain these instructions for future service and adjustments
615 South Street, Garden City, NY 11530
Tel: [phone] Fax [phone]
www.waclighting.com
Wiring of multiple units:
In addition to hard wiring multiple fixtures, components are provided to allow fixtures to be joined through surface
wiring.
Note: The total fixtures of all connected fixtures should not exceed 6 pieces.
End to End Connection ( I-connector included ) :
The “I” connector allows two fixtures to connected end to end.
1. Pry out the plastic covers concealing the female connection ports at the end of the fixtures.
2. The “I” connector has one square shaped connector and two rounds to assure the correct orientation.
3. Insert one end of the “I” connector into the fixture. Slide the second fixture to first one.
4. Secure position by mounting fixtures to the surface.
Using a jumper wire ( Sold Separately ) :
A surface mount jumper wire allows multiple units to be linked through surface wiring.
1. Pry out the plastic covers concealing the female connection ports at the end of the fixtures.
2. The jumper wire has one square shaped connector and two rounds to assure correct orientation.
3. Insert the ends of the connectors into each fixture.
4. Jumper wires have metal strain relief cover brackets. Slide the cover bracket over the connector. Position
the bracket so that the hole in the bracket aligns with the hole in the fixture. Use the screw supplied, to
secure the cover bracket to the fixture.
5. Wrap excess wire with nylon wire ties if necessary.
Jumper wire
“I” Connector