Installation & Assembly

WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. MAY 11, 2016 11:58 AM
waclighting.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
3
INSTALLATION INSTRUCTION
Accent
5011
Step 3: Installing the Fixture
8. Screw the xture onto the stake provided, leading the wire from
the xture through the wire slot in the stake.
9. If desired, bury your wire by digging a small trench. Close the
trench by applying an inward force to both sides of the trench.
10. Repeat steps for other xtures in the same electrical circuit.
11. Turn the main power supply back on and make sure the xtures
light up.
Step 4: Aiming the Fixture
12. Tilting: Loosen the joint screw and adjust the head of the xture
to the desired direction before retightening the screw.
13. Rotating: Loosen the mounting knob and rotate the xture to
the desired position before retightening the knob.
Step 5: Dimming Adjustment:
14. Use a Phillips head screwdriver to adjust the dimming dial.
15. Rotate until the arrow on the dial is pointed at the desired
wattage. The wattage may be adjusted to the pre-existing tabs
or any value in between.
16. The lower the wattage, the dimmer the xture will be.
17. Please refer to the yellow tag to determine the size of the
required transformer.
4W
2W
8W
13W
16W
Model: 5011
Joint Screw
Mounting
Knob
Tilting
Rotating
Runs to
the next
xture
Transformer