Installation & Assembly

WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. MAY 11, 2016 11:58 AM
waclighting.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
2
INSTALLATION INSTRUCTION
Accent
5011
Mounting Stake
Qty: 1pcs
Outdoor Rated Wire Nut
Qty: 2pcs
Hex Key
Qty: 1pcs
Adjustable Shroud
Qty: 1pc
MOUNTING ACCESSORIES
Step 1: Determining the location
1. Make sure your main power is o.
2. At the point of installation, mount the stake by placing a piece
of wood on the stake and hammering the wood.
Hammer till the bottom of the ring is ush with the ground.
3. In the case of hard soil, dig a hole and place the stake in so that
the bottom of the ring is ush with the ground.
Fill the rest of the hole with the removed soil and pack it tight
to secure the stake.
4. Screw the xture onto the stake provided, leading the wire from
the xture through the wire slot in the stake.
Step 2: Wiring the Fixture
*Note: Transformer is required to power the xture. (sold separately)
5. Cut the power supply wire from the transformer at the location
of the xture.
6. Separate the power supply wire into two individual wires by
lightly pulling on each side so that a couple inches is separated.
7. Strip o ½ inch of the insulating material from each wire and
connect one to each of the wires from the xture using the
outdoor rated direct burial wire nuts provided.
Note: To install multiple xtures, also connect the power
supply wire of each additional xture to the connection
described in 7 of the previous xture.
Hammer
Wood
Mounting Stake
Soil
Transformer
To Next Fixture
Mounting Stake
Fixture Wires
Wire Slot
Accent Lighting Fixture