Users Manual

3.1.8 Capture function
This function can turn on or off the function of capturing user's
photos during temperature measurement. It is turned on by default in the
factory, and the captured photos can be viewed by the management
personnel.If it is used in occasions where users' privacy needs to be
protected, the administrator can close it by himself.
(1) Click "capture function" to select whether to turn on the capture switch
according to the use scenario.
3.2 Temperature
3.2.1 High temperature alarm value setting
This function allows the administrator to set the temperature abnormal
alarm value by himself,
For example
：
if the temperature is set to 37.2 ℃, the test temperature value will exceed
37.2
℃
, and the equipment will give an alarm (the temperature value ≤ 37.2
℃
will not give an alarm, and the temperature value ≥ 37.3 ℃).
(1) Click "high temperature alarm value setting", set the alarm value, and click
"save".The factory default setting is 37.2 ℃.