link300.4mini 300W RMS 4-Channel Amplifier Owner’s Manual www.wavtech-usa.
WARNING CAUTION This symbol means important instructions. Failure to heed them can result in serious injury or death. This symbol means important instructions. Failure to heed them can result in injury or property damages. • DO NOT DRIVE WHILE DISTRACTED. WARNING Any function that requires your prolonged attention should not be performed while driving. Always stop the vehicle in a safe location before performing any such function. Failure to do so may result in an accident.
Introduction Welcome to Wāvtech, exceptional mobile audio products for audiophiles. Our products are engineered from the ground up to provide a truly remarkable listening experience with superior performance, sound quality and reliability. Built for the professional installer, our innovative features enable maximum application coverage with ultimate system flexibility.
Top Panel Controls Œ Input Channel: These switches are for selecting which input channels feed the Œ Ž ‘ respective channel pair's pre-amp and output stages. CH1/2 can be set to direct (1/2) or sum (1+3/2+4), while CH3/4 can be set to copy (1/2), direct (3/4) or sum (1+3/2+4). For 2-channel sources, connect the source to CH1/2's RCA or speaker level inputs and set CH3/4's input select to copy (1/2), or use y-adapters/jumper wires and set to direct (3/4) to allow CH3/4's gain to be used separately.
Power Supply & Output Panel Connections Œ Power Supply Terminal: Ž Ÿ Ground (GND): The ground terminal must be connected to a metal part of the vehicle with Œ ground plane back to the main battery ground attachment point (a.k.a. chassis ground). This wire should be as short as possible, but no longer than 2ft (60cm), with minimum gauge of 8AWG.
RCA Input Wiring: CH1 (L) CH2 (R) Speaker Level Input Wiring: CH3 (L) CH4 (R) Note: For a 2-channel source, connect to CH1/2 inputs and select copy (1/2) with CH3/4's INPUT CH switch. If separate gain control is desired for CH3/4, use RCA y-adapters or jumper wires to connect CH1/2 to CH3/4's inputs externally and select direct (3/4) with CH3/4's INPUT CH switch.
Specifications Power Output link300.4mini 14.
Warranty & Service Care Wāvtech warrants this product to be free from defects in material and workmanship for a period of one (1) year when purchased from an authorized Wāvtech retailer within the United States. This warranty will be extended to a period of two (2) years when the installation is performed by an authorized Wāvtech retailer. A valid sales receipt is required to verify eligibility of purchase and installation.
