Technical data

70
W&T
After logging in again and opening Config >> Session
Control >> LogOut the Stopp Box2Box Slave button will be
shown. Clicking on the button resets the Slave to Box-to-Box
mode.
3.9.6 Preconfiguring Box-to-Box for another network
You can configure Box-to-Box mode from your desk. Then carry
out the following steps (Master = Client, Slave = Server):
Master: Use Binary disable to close the connection, then save.
Now the slave is ready to accept a new connection.
Slave: Set network address to the destination network, then
save. Now the device is no longer accessible to you after a reset.
Master: Binary enable, TCP-Client enter new slave IP address. Set
network address to the destination network, then save. Now the
device is no longer accessible to you after a reset.
When changing the IP address please be sure you are also using
the correct subnet mask and gateway address.
Now both devices will automatically connect to each other in
the new network.