Technical data

W&T

This means for example that the inputs which control the

outputs on the Master Web-IO can at the same time be read out

over HTTP.

"Input Trigger" allows sending based on an input change. Use

“Hysteresis” to specify how great the change should be in order

for a new value to be sent.

Interval:

If no interval is entered, the state of the inputs is sent to the

outputs of the other respective Box-to-Box partner whenever

there is a change. By entering an interval the state is also sent

cyclically even when there is no change.

If two locations are connected to each other over a fee-

based ISDN line, use of an interval is discouraged since

the ISDN connection may either be never disconnected or often

reopened depending on the timeout and interval.

Recommendation for fast response to changes with the

least possible network load: Set interval to 2s and enable

Input Trigger with a hysteresis value which allows relevant

signal changes to be detected.

Application Mode

Select Box2Box Master

After all the parameters have been entered confirm by clicking

on the Temporary Storage button.

Now in the navigation tree select: Config >> Ports >> Port 1 >>

Output Mode