Technical data

65
W&T
Subject to errors and modifications
Local Port
Unless otherwise specified by your network administrator, the
factory default setting AUTO can be used.
ServerPort
Here the Local Port for the Slave must be entered. Here again
the basic setting 49153 can be used unless otherwise specified
by the network administrator.
i
Local Port and Slave Port do not necessarily have to be set
the same as the factory default settings.
One reason for changing the factory default settings for Local
and Slave Port may be for example a fireweall which permits
access only to a particular port.
Server HTTP Port
Specifies the HTTP port on which the control connection is to
be opened to the Slave box.
Unless otherwise specified, always use Port 80 here.
Server IP Addr
Enter here the IP address of the Web-IO to be used as a Slave.
Server Password
Here the administrator password of the Slave-IO is entered. If
no password has been assigned for the Slave, this field remains
blank.
Inactive Timeout
This parameter has no function in Box-to-Box mode, since a
permanent connection is desired.
Binary Trigger
Activate here the inputs which the corresponding outputs
should set for the Slave.
i
The Web-IO Anaog-In/Out allows simultaneous access
to the inputs from various modes...