Technical data

W&T

Now in the navigation tree select: Config >> Device >> Basic

Settings >> Binary1 >> TCP-Server

Local Port

Unless your network administrator has informed you otherwise,

the factory default set Port 49153 may be used.

One reason for changing the factory default set local port may

be for example a fireweall which permits access only to a

particular port.

In any case the set local port on the Slave must be

identical to the Server Port entry for the Master.

Client HTTP Port

Specifies which HTTP port to be used for opening the control

connection to the Master box.

Unless otherwise specified, always use Port 80 here.

Binary Trigger

Here you activate the inputs which are to set the corresponding

outputs on the Master.

The Web-IO Analog-In/Out allows simultaneous access to

the input from various modes.

This means for example that the inputs which control the

outputs on the Master Web-IO can at the same time be read out

over HTTP.

Application Mode

Select Box2Box Slave

After all the parameters have been entered, confirm by clicking

on the Temporary Storage button.

Now in navigation tree: Config >> Ports >> Port 1 >> Output

Mode