Technical data

W&T

Server HTTP Port

Is only relevant for Box2Box mode and specifies the HTTP port

on which a control line should open a connection to the slave

box.

Unless otherwise specified, always use Port 80 here.

Server IP Addr

Enter here the IP address of the server.

Server Password

A server password only needs to be entered if the Web-IO is

used as a Box-to-Box Master or needs to access a different Web-

IO as a TCP client in Server mode. More about this in the Box-

to-Box section.

Inactive Timeout

Here a timer is configured. After the time expires, the Web-IO

closes the TCP connection. The value is entered in decimal and

in 100ms increments. The timer is reset during an active

connection when data are exchanged.

Example: The value 10 corresponds to one second. If no data

transfer is detected for one second, the Web-IO closes the

connection.

If no value is entered, automatic connection closing is

disabled..

Binary Trigger

Here you select the ports whose status change should act as a

trigger for opening the TCP connection and sending data to the

server (important for event-triggered applications).

Interval

If you want the status of the inputs to be sent cyclically to the

server application, you can enter here the interval in 100ms

increments.

Example: A value of 300 corresponds to 30 seconds.