Technical data

W&T

Application Mode

Select here:

. Socket Device - If you want access to the Web-IO password

protected.

. Compatible 50xxx - If you want access to the Web-IO using

applications which were programmed for the older Digital

I/O Com-Servers. You can also use this mode for new

applications that do not require password protection.

A more detailed discussion of Box2Box Slave and OPC

Device modes can be found in the corresponding

sections.

After all your settings have been made, send them to the Web-

IO by clicking on the Temporary Storage button.

In addition, the ports used must be enabled for Binary Mode.

In the navigation tree select Config >> Ports >> Port X >> Out-

put Mode and highlight the desired binary access.

m Necessary access rights: Administrator

After all the entries have been made, send the setting by

clicking on the Logout button. Click on the Save button to

activate the settings.

All configuration possibilities shown for Binary 1

may also be used for Binary 2.