Technical data

W&T

Properties of device regarding HTTP have to be configurated on

Config >> Devices >> Basic Settings >> HTTP.

Startup: Specify here which HTML page you want displayed

when the device starts up.

Enable: The device can, when polled using an HTTP-Get

command, also send along with the measured value a header

with the IP address and name of the device. Check the

corresponding box to enable this. If this function is disabled

only the actual measurement is sent.

The function GET HTTP enable is a special SAP application. If

enabled the connection is closed automatically after device

reply.

HTTP Port: You can use this port to access the device. The

factory default setting is the standard HTTP port 80. If you want

to use a different port, this may need to be explicitly names

when opening the page:

http://<ip address>:<PortNr>

For the usage of HTTP commands „GET /...“ please refer chapter

4 „Individual Measurement Polling“.