Technical data

37
W&T
Subject to errors and modifications
„Send Testpulses, please wait ...“
After clicking the button the device begins with the automatic
compensation. The test pulses with a capacity of 100µF appear
as follows:
Value: The device enters the determined compensation value
automatically. This value is valid immediately. The value can
also be set manually. Subsequently, the desired value which was
present before the determination will be adjusted again.
Mode:
Auto adaptive enable: The device determines the compensation
at run-time. Here no compensation value must be registered.
The disadvantage here is in the fact that constantly changing
capacities must be measured first, until the initial value fits
again correctly.
Use saved value at power on: If this function is activated, the
adjusted compensation value is used immediately after starting
the device.