Technical data

W&T

Subject to errors and modifications

Output Mask:

Here you specify which operating mode is used for each

output. The factory default setting for all ports is HTTP.

Please note that for most of the modes you must make a few

other settings in addition to output mode, such as enabling the

operating mode. Additional information can be found in the

description for the respective operating mode.

Please note when using the active input that in Output

Mode “Output OFF” causes passive Input Mode to be set

for Config >> Ports >> Port x. This protects the hardware

from inadvertent damage. The active input must then be

selected again and saved.

Safety State / Timeout / Value

If no network activity is detected for the timeout time set here,

the Web-IO Analog-In/Out sets the outputs to a configurable

value (Safety Value).

After selecting the output modes click on Temporary Storage

to sent the settings to the device. Use the Logout button to

activate the settings and then click on Save.