Technical data

32
W&T
3.1.3 Port Config
In the Port-Config menu you can specify which values are
displayed when then input is in between 0% and 100% of the
scale . This entry also refers to the data logger and the output
value.
Example:
0% -> 10
100% -> 3000
If there is no input signal on the unit (0%), it will show a value
of „10“. If you set your output to the value „10“ the device will
output 0V or 0mA .
If there is an input signal of 10V or 20mA on the unit (100%),
the value „3000“ is displayed. If you set your output to the
value „3000“ so the device will output 10V or 20mA.