Technical data

27
W&T
Subject to errors and modifications
End: Specify the end time point for the x-axis.
Sensors: Turn individual sensors for the display on and off.
Polling Rate: Enter here the desired polling rate for the graphical
display. The device makes a new value available no sooner than
0.5 seconds. Entering a value of less than 0,.5 has no effect.
Extreme: If in the graphical display a zoom level is selected in
which a display point represents a measurement interval and
not an individual measuring point, this function is used to
display the maximum and miminum measured during this
interval. If the zoom level is selected so that every measurement
is displayed, this function has no effect. If the function is
turned off, the average of the displayed interval is displayed.
Show alarm monitor: Uses a bar graph to show whether the
alarm monitor is active or inactive for the respective alarm.
Apply: The changes made are immediately applied to the
graphical display.