Technical data

154
W&T
Additional LEDs (internal)
■ on error http://xxx.xxx.xxx.xxx/diag -LED: Indicates an
internal configuration error. For troubleshooting open page
http://xxx.xxx.xxx.xxx/diag in the device. For remedied
errors delete under Diag Report.
■ system error: Major hardware error. Try to restart the device
by cycling power. If the fault is not cleared, please return
the device for service.
!
If the Web-Thermograph does not have an IP address or
the address is 0.0.0.0, the LEDs on error and system
error will remain on after a reset or new start! The
system error LED will flash 3x after a short time. Only when an
IP address has been assigned will the LEDs go out.
7.4 Emergency access
The device can be reset to its factory default settings in the
following manner:
1. Open the housing
The DIN rail mount housing is opened by plugging in the 6-pin
connector. After tightening both the fastening screws the board
can be removed from the housing by pulling on the connector.